"I don't know what the top speed is, but I have read on other forums of people running their Taig at 1000 and 1200mm per min. I have only had mine running for three weeks now and have only milled three wax successfully thus far. One and…"

"that's weird that the software won't let you type in a higher speed, what's the top end speeds of your mill, 500 mm per min is pretty slow I would think it is faster then that...I used protowizard to mill this one and milled it on the…"

"Again, I am new to this, the maximum speed I set using Deskproto is 500mm per min, and I don't think Mach 3 will let me go above 500mm per min either. What software are you using?  "

"I has a few cz's laying around to see the fit but nit enough to go all the way around...I ran the mill a liittle slow 1000mm per min x,travel with 7000 rpm you could go 1200mm per min if you want , no need to increase the rpms...I used a .010,…"

"That was quick, what speed do you have your mill running at?  "

"here you go...I scaled it down before milling, just wanted to see the finished wax after all the repair was done"

"No at all, have at it. "

"do you mind if I give it a try?"

"Yes, on my newly operational Taig mill. "

"garlton , are you gong to mill your ring?"

"All my past models have been a combination of solid pipes, that follow a curve, or pieces cut out of an extruded surface. So none of my past models have had naked edges as they were solid all the way through. This ring was easier to try by using the…"

"to check for naked edges ...go to the menu bar, analyze, edge tools, show edges"

"Thanx for the directions, I didn't know how to check for naked edges prior to your post. "

"join the party!, better late then never..I agree make it "a goal to avoid them "...the edge color usage is good to use!... also I like to use single color for all backfaces"

" as they say in all the classes I've takin... "The only way to avoid naked edges is to design your models the right way to begin with, always check as you go, and don't rely on fix naked edges to help you close…"